ICM40607 规格书

admin

PRODUCT OVERVIEW
The ICM-40607 is a 6-axis MotionTracking device that combines a 3-axis gyroscope, and a 3-axis accelerometer in a small 2.5x3x0.91mm (14-pin LGA) package. It also features a 2K-byte FIFO that can lower the traffic on the serial bus interface, and reduce power consumption by allowing the system processor to burst read sensor data and then go into a low-power mode. ICM-40607, with its
6-axis integration, enables manufacturers to eliminate the costly and complex selection, qualification, and system level integration of discrete devices, guaranteeing optimal motion performance for consumers.
The gyroscope supports eight independently programmable full-scale range settings from ±15.625dps to ±2000dps, and the accelerometer supports four independently programmable full-scale range settings from ±2g to ±16g. Other industry-leading features include on-chip 16-bit ADCs, programmable digital filters, an embedded temperature sensor, and programmable interrupts. The device features I2C and SPI serial interfaces, a VDD operating range of 1.71 V to 3.6 V, and a separate
VDDIO operating range of 1.71V to 3.6V.
The host interface can be configured to support I2C slave or SPI slave modes. The I2C interface supports speeds up to 1 MHz, and the SPI interface supports speeds up to 24 MHz.
By leveraging its patented and volume-proven CMOS-MEMS fabrication platform, which integrates MEMS wafers with companion CMOS electronics through wafer-level bonding, InvenSense has driven the package size down to a footprint and thickness of 2.5x3x0.91 mm (14-pin LGA), to provide a very small yet high performance low cost package. The device provides high robustness by supporting 20,000g shock reliability

ICM40607规格书：